Making The Cut
Faux Stone is one of the most versatile products to hit the home improvement market. Cutting faux stone is simple and easy to do. Unlike stone cutting saws there is no need for expensive diamond blades, create messy dust or use water.
The polyurethane is durable yet light enough to allow for an easy cut with any saw. The table saw ensures the straightest and highest quality cut but any saw with a steady hand or a straight edge.
If you look in your garage or your toolbox and do not find one do not worry you will still be able to use any other kind of saw such as a jigsaw or circular saw in order to finish your project. If you do not have any equipment at all then go to the nearest home improvement store and simply rent one. This will still be cheaper than any other method in the long run; like using real stone or hiring a mason.
The main thing you should be focused on while doing your project is the proper preparation. Make sure the area is flat and devoid of bumps and other blemishes. Lay out the panels around the installation area to plan which panel to cut and where to create corners and returns.
Do not fret because this only takes minutes. Some problems that arise while cutting is when people have pipes or fixtures and they need to put stone around it, which highlights the beauty and ease of faux stone. You may cut anywhere to fit your needs.
After you receive a panel you simply face it where you want and draw out the line where you need to cut in order to fit the piping. If you run into any problems such as having too much or little of a panel the large assortment of finished edges will fit to your needs thereby giving you the customized look and professional finished result when you are done with your project.
Here is a great example of the finished product after the corners and correct cuttings have been made.
Unlike other products, like cast stone, you can easily miter-cut the panels and create seamless joint. You can see how natural products are difficult to miter-cut and create a clean look. The material is very forgiving and you can cover any gap with caulking and using out touch-up kit to paint over it for a joint that will be very difficult to see.
Once you have established the exact area you need to cover draw out where the panels will go. Then apply how many you will need according to your design. Triple check your measurements and then confirm with the actual panels where you want them to go. Make sure to do the cutting as you go.
Do not start cutting right away or else you will not be able to keep a continuous flow of pattern. An example of an important cut is the miter cut which is used on the corners of columns or end of walls.
The goal is to stack the panels properly cutting off the edges in order to place them in a pattern. The edge that you cut off is not waster, you can use it to start then next row onto the level right above it and interlocks them into place that is why it is important to do your cutting as you go along.
A great place to find a picture step guide is on anticoelements.com/installation. So keep your saw and marker handy. Always, use your tape measure in order to ensure you are cutting off the right pieces. In order to ensure a professional look make sure edges are cut straight. Be safe and have fun with your next home transformation project.