One of the challenges of the imitation stone sheets is to organize and line up the panels so that the joints between two of them line up with a framing stud.
When installing faux stone panels you will have two staggered and interlocking edges that will slide into each other. The ideal installation would have the installer drive screws right where two panels overlap. If you have ordered panels that are not designed to line up with the studs then some of these screws will hit a stud, some will just go into the drywall and not provide you with a sturdy bond.
With the new Laguna stacked stone panels, this issue doesn’t exist. These new panels have been engineered to always have the joints fall on a stud; given that the installation is started correctly. To start the process correctly all you need to do is alight the first panel of each row properly and the rest of the panels will line up automatically.
As you can see in the images the Laguna faux stacked stone has lines embedded in the panels and with the word “stud” next to them. These new panels need to be installed from right to left and bottom to top. The product drawing of these stone panels will also show you where to drive the screws within the panels’ surface. We also suggest using a construction adhesive where the panels overlap and in the back.
It has never been easier to create a stone or brick wall look for less money and in a very short time.
In short, the difficult work has already being done. All the installer has to do is line up the first panel correctly and the rest of the work will be completed without any effort. Of course, sometimes the studs are not installed at the correct intervals but this should just be a temporary issue. After the next panels are installed the studs should start lining up again.
You may click HERE to view the Laguna line.